Audi S4 2011 Lower Control Arm Bushing Install: A Comprehensive Guide

Rear Lower Control Arm Bushing Audi (4H0407183C) Audi Usa Parts from www.audiusaparts.com

If you're an Audi S4 2011 owner, you may have noticed that your car's handling has become a bit off lately. This could be due to worn out lower control arm bushings, which are responsible for keeping the control arm in place and absorbing road shocks. Replacing these bushings can be a bit challenging, but it's a job that can be done with the right tools and some mechanical know-how. In this article, we'll take you through the steps of replacing your Audi S4 2011 lower control arm bushings.

What you'll need

Before we dive into the process of replacing the lower control arm bushings, let's take a look at the tools and parts you'll need:

Tools:

- Jack and jack stands - Torque wrench - Pry bar - Ball joint separator - Bushing removal tool - Rubber mallet - Socket set - Wrench set - Grease gun

Parts:

- New lower control arm bushings - New ball joint - New bolts and nuts

Step-by-Step Guide

Now that you have all the necessary tools and parts, let's get started on the process of replacing your Audi S4 2011 lower control arm bushings.

Step 1: Raise the car

Using a jack, raise the car and secure it with jack stands. Make sure the car is stable and won't move while you're working on it.

Step 2: Remove the wheel

Using a socket wrench, remove the lug nuts and take off the wheel. Set it aside in a safe place.

Step 3: Remove the brake caliper and rotor

Remove the brake caliper and rotor by taking out the bolts that hold them in place. Use a wire or bungee cord to secure the caliper to the suspension so it doesn't hang by the brake line.

Step 4: Disconnect the ball joint

Using a ball joint separator, disconnect the ball joint from the control arm. Make sure you don't damage the boot on the ball joint.

Step 5: Remove the control arm

Remove the bolts that hold the control arm in place, and then use a pry bar to remove the control arm from the subframe.

Step 6: Remove the old bushings

Using a bushing removal tool, remove the old bushings from the control arm.

Step 7: Install the new bushings

Using a rubber mallet, install the new bushings into the control arm. Make sure they are installed evenly and securely.

Step 8: Reinstall the control arm

Place the control arm back into the subframe and secure it with the bolts that you removed earlier. Tighten the bolts to the torque specifications listed in your car's manual.

Step 9: Install the ball joint

Install the new ball joint into the control arm and tighten the nut to the torque specifications listed in your car's manual.

Step 10: Reinstall the brake rotor and caliper

Put the brake rotor and caliper back into place and tighten the bolts to the torque specifications listed in your car's manual.

Step 11: Reinstall the wheel

Put the wheel back on and tighten the lug nuts to the torque specifications listed in your car's manual.

Step 12: Lower the car

Using a jack, lower the car back down to the ground and remove the jack stands.

Step 13: Grease the bushings

Using a grease gun, lubricate the new bushings to ensure they last longer and perform better.

Step 14: Test drive

Take your car for a test drive to ensure everything is working properly and that the handling is improved.

Conclusion

Replacing the lower control arm bushings on your Audi S4 2011 can be a bit challenging, but it's a job that can be done with the right tools and some mechanical know-how. By following the steps outlined above, you can ensure that your car's handling is improved and that it's safer to drive. Just remember to take your time and be patient, and you'll have your car running smoothly in no time.

audis4coupe

Search This Blog